DIN 87721-2:2017
Drain screws - Part 2: Screws, welding plates
- Standard No.
- DIN 87721-2:2017
- Release Date
- 2017
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN 87721-2 E:2017-03
- Latest
- DIN 87721-2:2017-11
- Replace
- DIN 87721-2:1995
- Scope
- The document lays down the design details of the screws and weld-in plates for the complete drain screw joint in accordance with DIN 87721-1.
DIN 87721-2:2017 Referenced Document
- DIN 13-7:1999 ISO general purpose metric screw threads - Part 7: Nominal sizes for 2 mm fine pitch threads; nominal diameter from 17 mm to 300 mm
- DIN 13-8:1999 ISO general purpose metric screw threads - Part 8: Nominal sizes for 3 mm fine pitch threads; nominal diameter from 28 mm to 300 mm
- DIN 76-1:2016 Thread run-outs and thread undercuts - Part 1: For ISO metric threads in accordance with DIN 13-1
- DIN 87721-1:2014 Drain screws - Part 1: Assembly, installation
- DIN EN 10025-2:2005 Hot rolled products of structural steels - Part 2: Technical delivery conditions for non-alloy structural steels; German version EN 10025-2:2004
- DIN EN 10088-3:2014 Stainless steels - Part 3: Technical delivery conditions for semi-finished products, bars, rods, wire, sections and bright products of corrosion resisting steels for general purposes; German version EN 10088-3:2014
- DIN EN 12163:2016 Copper and copper alloys - Rod for general purposes; German version EN 12163:2016
- DIN ISO 2768-1:1991 General tolerances; tolerances for linear and angular dimensions without individual tolerance indications; identical with ISO 2768-1:1989
DIN 87721-2:2017 history
- 2017 DIN 87721-2:2017-11 Drain screws - Part 2: Screws, welding plates
- 1970 DIN 87721-2 E:2017-03 Drain screws - Part 2: Screws, welding plates
- 2017 DIN 87721-2:2017 Drain screws - Part 2: Screws, welding plates
- 1995 DIN 87721-2:1995 Drain screws - Part 2: Screws, welding plates
- 0000 DIN 87721-2:1987
