This European Standard specifies the requirements and test methods for materials, dimensions and function for flexible hose assemblies for drinking water installations, braided or not, designed for use with drinking water with an allowable maximum operating pressure (PMA) of 1 MPa and maximum operating temperature 70 °C to connect sanitary tap ware, heaters and similar appliances. NOTE Flexible hose assemblies intended to be used as integral parts of electrical appliances are covered by EN 61770.
EN 13618:2016 Referenced Document
EN 1254-2:1998 Copper and Copper Alloys - Plumbing Fittings - Part 2: Fittings with Compression Ends for Use with Copper Tubes
EN 1254-3:1998 Copper and copper alloys - Plumbing fittings - Part 3: Fittings with compression ends for use with plastics pipes
EN 1254-4:1998 Copper and copper alloys - Plumbing fittings - Part 4: Fittings combining other end connections with capillary or compression ends
EN 248:2002 Sanitary tapware - General specification for electrodeposited coatings of Ni-Cr*， 2024-04-20 Update
EN 61770:2009 Electric appliances connected to the water mains - Avoidance of backsiphonage and failure of hose-sets
EN 806-2:2005 Specification for installations inside buildings conveying water for human consumption - Part 2: Design
EN ISO 1456:2009 Metallic and other inorganic coatings - Electrodeposited coatings of nickel, nickel plus chromium, copper plus nickel and of copper plus nickel plus chromium (ISO 1456:2009)
EN ISO 15875-2:2003 Plastics piping systems for hot and cold water installations - Crosslinked polyethylene (PE-X) - Part 2: Pipes Incorporates Amendment A1: June 2007*， 2024-04-20 Update
EN ISO 15876-2:2003 Plastics piping systems for hot and cold water installations - Polybutylene (PB) - Part 2: Pipes Incorporates Amendment A1: June 2007*， 2024-04-20 Update
EN ISO 22391-2:2009 Plastics piping systems for hot and cold water installations - Polyethylene of raised temperature resistance (PE-RT) - Part 2: Pipes (ISO 22391-2:2009)*， 2024-04-20 Update
EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation ISO 228-1: 2000
EN ISO 30013:2011 Rubber and plastics hoses - Methods of exposure to laboratory light sources - Determination of changes in colour, appearance and other physical properties (ISO 30013:2011)*， 2024-04-20 Update
EN ISO 9080:2012 Plastics piping and ducting systems - Determination of the long-term hydrostatic strength of thermoplastics materials in pipe form by extrapolation (ISO 9080:2012)*， 2024-04-20 Update
ISO 68-1:1998 ISO general purpose screw threads - Basic profile - Part 1: Metric screw threads
ISO 6957:1988 Copper alloys; ammonia test for stress corrosion resistance
ISO 7-1:1994 Pipe threads where pressure-tight joints are made on the threads - Part 1: Dimensions, tolerances and designation
EN 13618:2016 history
2016EN 13618:2016 Flexible hose assemblies in drinking water installations - Functional requirements and test methods
2011EN 13618:2011 Flexible hose assemblies in drinking water installations - Functional requirements and test methods