ASTM A1094/A1094M-16 PDF

Scope: 1.1 This specification covers steel reinforcing bars, with protective zinc or zinc-alloy coatings applied by the continuous hot-dip process.

Note 1: The galvanizer is identified throughout this specification as the manufacturer.

1.2 Guidelines for construction practices at the job-site are presented in Appendix X1.

1.3 Guidelines for use of continuous hot-dip galvanized reinforcing bars with non-galvanized steel forms are presented in Appendix X2.

1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered requirements of the specification.

1.5 This specification is applicable for orders in either inch-pound units (as Specification A1094) or SI units (as Specification A1094M).

1.6 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

1.7 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM A1094/A1094M-16 Referenced Document

ASTM A615/A615M Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement
ASTM A706/A706M Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement
ASTM A780/A780M Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings
ASTM A90/A90M Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings
ASTM A996/A996M Standard Specification for Rail-Steel and Axle-Steel Deformed Bars for Concrete Reinforcement
ASTM B487 Standard Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section
ASTM B6 Standard Specification for Zinc
ASTM B852 Standard Specification for Continuous Galvanizing Grade (CGG) Zinc Alloys for Hot-Dip Galvanizing of Sheet Steel
ASTM E376 Standard Practice for Measuring Coating Thickness by Magnetic-Field or Eddy-Current (Electromagnetic) Test Methods

2020 ASTM A1094/A1094M-20 Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement
2018 ASTM A1094/A1094M-18 Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement
2016 ASTM A1094/A1094M-16 Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement
2015 ASTM A1094/A1094M-15a Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement
2015 ASTM A1094/A1094M-15 Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement