EN 13241-1:2003+A1:2011 Industrial, commercial and garage doors and gates - Product standard - Part 1: Products without fire resistance or smoke control characteristics
This European Standard specifies the safety and performance requirements for doors, gates and barriers, intended for installation in areas in the reach of persons, and for which the main intended uses are giving safe access for goods and vehicles accompanied or driven by persons in industrial, commercial or residential premises. This European Standard also covers commercial doors such as rolling shutters and rolling grilles used in retail premises which are mainly provided for the access of persons rather than vehicles or goods. These doors can include pass doors incorporated in the door leaf which are also covered by this European Standard. These devices can be manually or power operated. This European Standard does not cover operation in environments where the electromagnetic disturbances are outside the range of those specified in EN 61000-6-3. Exclusions This European Standard does not apply to the following which are intended for a different use: lock gates and dock gates; doors on lifts; doors on vehicles; armoured doors; doors mainly for the retention of animals; theatre textile curtains; horizontally moving manually operated pedestrian doors with a leaf size less than 6,25 m2; horizontally moving power operated doors less than 2,5 m wide and 6,25 m2 area, designed principally for pedestrian use in accordance with prEN 12650-1; revolving doors of any size; railway barriers; barriers used solely for vehicles. This European Standard does not cover the radio part of doors. If a radio operating device is used, the relevant ETSI standards should be applied in addition. This European Standard does not contain any specific requirements for fire resistance or smoke control characteristics which are covered in prEN 13241-2. This European Standard does not contain any specific requirement for doors which are moving because of energy stored by dedicated means from human power such as manually tensioned springs. This European Standard does not contain any specific requirements for doors on escape routes. The ability to open the door leaf safely and easily cannot normally be achieved by industrial, commercial and garage doors due to size, weight and/or mode of operation. The noise emission of powered doors and gates is not considered to be a relevant hazard. Therefore this European Standard does not contain any specific requirements on noise in relation to the Machinery Directive. Specific applications This European Standard should also apply to power operated doors which have been created by the addition of power operation to an installed manual door in respect of the relevant requirements. Annex ZA does not apply to this kind of door. It also identifies requirements and classes of performance for additional characteristics considered to be of importance to the trade. When a door is part of the load carrying structure of the building the requirements of this European Standard can apply on a voluntary basis in addition to the requirements for the load carrying structure, which are not dealt with in this European Standard. Annex ZA does not apply for this kind of doors.
EN 13241-1:2003+A1:2011 Referenced Document
EN 1037:1995 Safety of machinery - Prevention of unexpected start-up (Incorporates Amendment A1: 2008)
EN 12424:2000 Industrial, commercial and garage doors and gates - Resistance to wind load - Classification
EN 12425:2000 Industrial, commercial and garage doors and gates - Resistance to water penetration - Classification
EN 12426:2000 Industrial, commercial and garage doors and gates - Air permeability - Classification
EN 12427:2000 Industrial, commercial and garage doors and gates - Air permeability - Test method
EN 12428:2000 Industrial, Commercial and Garage Doors and Gates - Thermal Transmittance - Requirements for the Calculation
EN 12433-1:1999 Industrial, commercial and garage doors and gates - Terminology - Part 1: Types of doors
EN 12433-2:1999 Industrial, commercial and garage doors and gates - Terminology - Part 2: Parts of doors
EN 12444:2000 Industrial, commercial and garage doors and gates - Resistance to wind load - Testing and calculation*， 2024-04-20 Update
EN 12445:2000 Industrial, Commercial and Garage Doors and Gates - Safety in Use of Power Operated Doors - Test Methods*， 2024-04-20 Update
EN 12453:2000 Industrial, Commercial and Garage Doors and Gates - Safety in Use of Power Operated Doors - Requirements*， 2024-04-20 Update
EN 418:1992 Safety of machinery; emergency stop equipment, functional aspects; principles for design
EN 13241-1:2003+A1:2011 history
2011EN 13241-1:2003+A1:2011 Industrial, commercial and garage doors and gates - Product standard - Part 1: Products without fire resistance or smoke control characteristics
2003EN 13241-1:2003 Industrial, commercial and garage doors and gates - Product standard - Part 1: Products without fire resistance or smoke control characteristics (Incorporating corrigendum July 2003; Incorporates Amendment A1: 2011)