This European Standard specifies requirements relating to the construction, performance and methods of testing for membrane separation systems with a particle rating below 1 µm, namely microfiltration (MF), ultrafiltration (UF), nanofiltration (NF) and reverse osmosis (RO) for drinking water installations inside buildings, intended to remove from the drinking water marginal concentrations of suspended and colloidal solids, microorganisms, organic molecules and/or to reduce the dissolved solids concentration and applies to systems with a minimum pressure of PN 10, connections between DN 15 and DN 100 and a maximum working temperature of at least 30 °C. This European Standard applies to membrane separation systems, whose elements may be partly or entirely cleanable or disposable in accordance with the type of system. It only concerns units which are permanently connected to the mains supply at the point-of-entry or the point-of-use. A membrane separation system may include, together with the separation device pre- and /or post-treatment devices. For the scope of this European Standard: separation device shall comply with this European Standard, i.e. without pre-and/or post-treatments; where pre-and/or post-treatment devices are incorporated in the system, each of them shall conform to the relevant standard. If this is the case, the complete system shall be considered as conforming as a whole.
EN 14652:2005+A1:2007 Referenced Document
EN 1092-1:2001 Flanges and Their Joints - Circular Flanges for Pipes, Valves, Fittings and Accessories, PN Designated - Part 1: Steel Flanges
EN 1092-2:1997 Flanges and their joints - Circular flanges for pipes, valves, fittings and accessories, PN designated - Part 2: Cast iron flanges
EN 1254-1:1998 Copper and Copper Alloys - Plumbing Fittings - Part 1: Fittings with Ends for Capillary Soldering or Capillary Brazing to Copper Tubes
EN 1567:1999 Building valves - Water pressure reducing valves and combination water pressure reducing valves - Requirements and tests
EN 1717:2000 Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow*， 2024-04-20 Update
EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation ISO 228-1: 2000
EN ISO 3696:1995 Water for Analytical Laboratory Use- Specification and Test Methods (ISO 3696 : 1987)
EN ISO 3822-1:1999 Acoustics ?Laboratory tests on noise emission from appliances and equipment used in water supply installations ?Part 1: Method of measurement Incorporates Amendment A1: 2008
EN ISO 3822-2:1995 Acoustics - Laboratory Tests on Noise Emission from Appliances and Equipment Used in Water Supply Installations - Part 2: Mounting and Operating Conditions for Draw-Off Taps and Mixing Valves (ISO 3822-2 : 1995)
EN ISO 3822-3:1997 Acoustics - Laboratory Tests on Noise Emission from Appliances and Equipment Used in Water Supply Installations - Part 3: Mounting and Operating Conditions for In-Line Valves and Appliances Incorporates Amendment A1: 2009
EN ISO 3822-4:1997 Acoustics - Laboratory Tests on Noise Emission from Appliances and Equipment Used in Water Supply Installations - Part 4: Mounting and Operating Conditions for Special Appliances
ISO 7-1:1994 Pipe threads where pressure-tight joints are made on the threads - Part 1: Dimensions, tolerances and designation
EN 14652:2005+A1:2007 history
2007EN 14652:2005+A1:2007 Water conditioning equipment inside buildings - Membrane separation devices - Requirements for performance, safety and testing
2005EN 14652:2005 Water conditioning equipment inside buildings - Membrane separation devices - Requirements for performance, safety and testing (Incorporates Amendment A1: 2007)