GB/T 20819.1-2015 Controllers with analogue signals for use in industrial-process control system.Part 1:Methods of evaluating the performance (English Version)
This Part of GB/T 20819 applies to PID pneumatic and electric industrial process regulators with continuous analog input and output signals in compliance with current national standards. It should be noted that the tests specified in this section cover tests with corresponding signals, and are applicable to regulators with the same principle but different signals but all continuous signals. It should also be noted that this section applies to electric or pneumatic industrial process regulators with only analog components, and can be implemented with reference to regulators with microprocessors. The purpose of this standard is to specify a uniform test method for the performance evaluation of industrial process PID regulators with analog input and output signals. When there are no other agreed conditions between the manufacturer and the user, use the test conditions specified in this section, such as ambient temperature, power range, etc. When it is not necessary to conduct a comprehensive assessment according to this part, the required tests can be carried out according to the relevant parts of this part, and the test results should be reported. Manufacturers and users should reach an agreement on the test procedures based on the characteristics and scope of use of the equipment.
GB/T 20819.1-2015 Referenced Document
GB 4793.1-2007 Safety requirements for electrical equipment for measurement,control,and laboratory use.Part 1:General requirements
GB/T 17626.2-2006 Electromagnetic compatibility Testing and measurement techniques Electrostatic discharge immunity test
GB/T 17626.3-2006 Electromagnetic compatibility Testing and measurement techniques Radiated, radio-frequency, electromagnetic field immunity test
GB/T 18271.1-2000 Process measurement and control devices--General methods and procedures for evaluating performance--Part 1: General considerations
GB/T 18271.3-2000 Process measurement and control devices--General methods and procedures for evaluating performance--Part 3: Tests for the effects of influence quantities
GB/T 18271.4-2000 Process measurement and control devices-General methods and procedures for evaluating performance-Part 4:Evaluation report content
GB/T 2423.10-2008 Environmental testing for electric and electronic products.Part 2:Tests methods Test Fc:Vibration(sinusoidal)
GB/T 2423.4-2008 Environmental testing for electrical and electronic products - Part 2: Test method Test Db alternating damp heat (12h + 12h cycle)
GB/T 2423.7-1995 Environmental testing for electric and electronic products. Test 2:Test methods. Test Ec and guidance:Drop and topple. Primarily for equipment-type specimens