ASTM F3131-14
Standard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages
- Standard No.
- ASTM F3131-14
- Release Date
- 2014
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM F3131-14(2023)
- Latest
- ASTM F3131-14(2023)
- Scope
1.1 This specification covers basic characteristics required for porous laminated Epoxy materials intended for use as instrument and thin-section ball-bearing retainers (cages) and the methods of determining these characteristics.
1.2 Forms—Sheets and Rolled Tubes are recommended forms of laminated material covered by this specification.
1.3 Intended Use—Materials produced to this specification are intended for use as ball bearing retainers (cages). Temperature range is limited to 284°F (140°C) and below
1.4 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F3131-14 Referenced Document
- ASTM D2257 Standard Test Method for Extractable Matter in Textiles
- ASTM D229 Standard Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation
- ASTM D570 Standard Test Method for Water Absorption of Plastics
- ASTM D618 Standard Practice for Conditioning Plastics for Testing
- ASTM D695 Standard Test Method for Compressive Properties of Rigid Plastics
- ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-20 Update
- ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
- ASTM E1640 Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis
ASTM F3131-14 history
- 2023 ASTM F3131-14(2023) Standard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages
- 2014 ASTM F3131-14 Standard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages
