ASTM B945-06(2014)
Standard Practice for Aluminum Alloy Extrusions Press Cooled from an Elevated Temperature Shaping Process for Production of T1, T2, T5 and T10–Type Tempers
- Standard No.
- ASTM B945-06(2014)
- Release Date
- 2006
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM B945-21
- Latest
- ASTM B945-21
- Scope
1.1 This practice establishes the controls necessary for production of extrusions cooled from an elevated temperature shaping (extrusion) process for the production of T1, T2, T5 and T10–type tempers (see ANSI H35.1).
1.2 This practice is for production of extruded product supplied in the alloys shown in Table 1 in the T1, T2, T5 or T10–type tempers. It contains pertinent information to be used in establishing production practices and is descriptive rather than prescriptive.
(A) These upper limit temperatures avoid the possibility of eutectic melting due to overheating, and include a safety factor of approximately 25°F.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM B945-06(2014) Referenced Document
- ASTM B557 Standard Test Methods of Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products
- ASTM B647 Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage
- ASTM B881 Standard Terminology Relating to Aluminum- and Magnesium- Alloy Products
- ASTM B918 Standard Practice for Heat Treatment of Wrought Aluminum Alloys
- ASTM E10 Standard Test Method for Brinell Hardness of Metallic Materials
- ASTM E18 Standard Test Methods for Rockwell Hardness of Metallic Materials
- ASTM E2281 Standard Practice for Process Capability and Performance Measurement
- ASTM E648 Standard Test Method for Critical Radiant Flux of Floor-Covering Systems Using a Radiant Heat Energy Source
ASTM B945-06(2014) history
- 2021 ASTM B945-21 Standard Practice for Aluminum Alloy Extrusions Press Cooled from an Elevated Temperature Shaping Process for Production of T1, T2, T5 and T10-Type Tempers
- 2006 ASTM B945-06(2014) Standard Practice for Aluminum Alloy Extrusions Press Cooled from an Elevated Temperature Shaping Process for Production of T1, T2, T5 and T10–Type Tempers
- 2006 ASTM B945-06 Standard Practice for Aluminum Alloy Extrusions Press Cooled from an Elevated Temperature Shaping Process for Production of T1, T2, T5 and T10-Type Tempers
