VDI/VDE/DGQ 2618 Blatt 16.1-2009 PDF

Scope: This part of the guideline applies to the calibration of height gauges featuring digital recording of the measurand at a numerical interval of <= 5 µm. It applies to designs suitable for length measurements only as well as those with additional means for straightness and perpendicularity measurements. The necessary working sequences are described.

VDI/VDE/DGQ 2618 Blatt 16.1-2009 Referenced Document

DIN 2250-1:2008 Geometrical product specifications (GPS) - GO ring gauges and setting ring gauges - Part 1: From 1 mm up to 315 mm nominal diameter
DIN 876-1:1984 Surface plates; natural hard rock surface plates; requirements and testing
DIN EN ISO 1101:2008 Geometrical Product Specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out (ISO 1101:2004); German version EN ISO 1101:2005
DIN EN ISO 3650:1999 Geometrical product specifications (GPS) - Length standards - Gauge blocks (ISO 3650:1998); German version EN ISO 3650:1998
VDI 1000-2006 Richtlinienarbeit - Grundsaetze und Anleitungen
VDI/VDE/DGQ 2618 Blatt 1.1-2001 Inspection of measuring and test equipment - Instructions to inspect measuring and test equipment for geometrical quantities - Basic principals
VDI/VDE/DGQ 2618 Blatt 1.2-2003 Inspection of measuring and test equipment - Instructions for the inspection of measuring and test equipment for geometrical quantities - Uncertainty of measurement

2009 VDI/VDE/DGQ 2618 Blatt 16.1-2009 Inspection of measuring and test equipment - Test instruction for height gauges
2007 VDI/VDE/DGQ 2618 Blatt 16.1-2007 Inspection of measuring and test equipment - Test instruction for height gauges