ISO 10447:2015
Resistance welding - Testing of welds - Peel and chisel testing of resistance spot and projection welds
- Standard No.
- ISO 10447:2015
- Release Date
- 2015
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 10447:2022
- Latest
- ISO 10447:2022
- Scope
- This International Standard specifies the procedures and recommended tooling to be used for peel and chisel testing of resistance spot and projection welds. This International Standard applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm. — weld size and failure type when welds are destructively tested, and — verification of welds by non-destructive chisel tests. NOTE The preferred method of peel testing seam welds (mechanized peel testing) is covered in ISO 14270.
ISO 10447:2015 Referenced Document
- ISO 14270:2000 Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds
- ISO 14329:2003 Resistance welding - Destructive tests of welds - Failure types and geometric measurements for resistance spot, seam, and projection welds
- ISO 17677-1:2009 Resistance welding - Vocabulary - Part 1: Spot, projection and seam welding
ISO 10447:2015 history
- 2022 ISO 10447:2022 Resistance welding — Testing of welds — Peel and chisel testing of resistance spot and projection welds
- 2015 ISO 10447:2015 Resistance welding - Testing of welds - Peel and chisel testing of resistance spot and projection welds
- 2006 ISO 10447:2006 Resistance welding - Peel and chisel testing of resistance spot and projection welds
- 1991 ISO 10447:1991 Welding; peel and chisel testing of resistance spot, projection and seam welds
