SAE J617-2014 PDF

Scope: This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face. This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded. This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mou

SAE J617-2014 Referenced Document

ASME B1.1-1989 Unified inch screw threads (UN and UNR thread form)
ASME Y14.5-1966 Dimensioning and Tolerancing
ISO 7648:1987 Flywheel housings for reciprocating internal combustion engines; Nominal dimensions and tolerances
ISO 7649:1991 Clutch housings for reciprocating internal combustion engines; nominal dimensions and tolerances
SAE J1033-2012 Procedure for Measuring Bore and Face Runout of Flywheels, flywheel housings and Flywheel Housing Adapters
SAE J1172-2012 Engine Flywheel Housings with Sealed Flanges
SAE J542-1991 Starting Motor Mountings
SAE J543-1995 Starting Motor Pinions and Ring Gears
SAE J615-2008 Engine Mountings
SAE J616-2008 Engine Foot Mounting (Front and Rear)
SAE J621-2012 Industrial Power Take-offs with Driving Ring-Type Overcenter clutches

2020 SAE J617-2020 Engine Flywheel Housing and Mating Transmission Housing Flanges
0000 SAE J617-201404
2014 SAE J617-2014 Engine Flywheel Housing and Mating Transmission Housing Flanges
2012 SAE J617-2012 Engine Flywheel Housing and Mating Transmission Housing flanges
1992 SAE J617-1992 Engine Flywheel Housing and Mating Transmission Housing Flanges
1976 SAE J617C-1976 ENGINE FLYWHEEL HOUSINGS