This International Standard specifies the techniques for manual ultrasonic testing of claddings on steel applied by welding, rolling, and explosion using Single-element or dual-element probes.
The test is intended to cover detection of two-dimensional or three-dimensional discontinuities in the cladding and in the region ofthe interface.
This International Standard does not give acceptance criteria nor define the extent of testing.
ISO 17405:2014 Referenced Document
EN 12668-1:2010 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: Instruments
EN 12668-2:2010 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 2: Probes
EN 12668-3:2013 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment*, 2024-04-20 Update
EN 1330-2:1998 Non destructive testing - Terminology - Part 2: Terms common to the non-destructive testing methods
EN 1330-4:2010 Non-destructive testing - Terminology - Part 4: Terms used in ultrasonic testing
ISO 2400:2012 Non-destructive testing - Ultrasonic testing - Specification for calibration block No. 1
ISO 7963:2006 Non-destructive testing - Ultrasonic testing - Specification for calibration block No. 2
ISO 17405:2014 history
2022ISO 17405:2022 Non-destructive testing — Ultrasonic testing — Technique of testing claddings produced by welding, rolling and explosion
2014ISO 17405:2014 Non-destructive testing - Ultrasonic testing - Technique of testing claddings produced by welding, rolling and explosion