ISO 3302-1:2014 PDF

Scope: This partofISO 3302 specifies classes ofdimensional tolerances andtheir values for moulded, extruded， and calendared solid rubber products. The relevant test methods necessary for the establishment of compliance with this part of ISO 3302 are also Specified. The tolerances are primarily intended for use with vulcanized rupber but can also be Suitable for products made ofthermoplastic rubbers. This part of ISO 3302 does not apply to precision toroidal sealing rings or to calendared composite products such as rubber-coated fabrics or products where arubber coating is applied by the process of topping or skim coating.

ISO 3302-1:2014 Referenced Document

ISO 2230:2002 Rubber products - Guidelines for storage
ISO 23529:2010 Rubber - General procedures for preparing and conditioning test pieces for physical test methods
ISO 3:1973 Preferred numbers; Series of preferred numbers
ISO 48:2010 Rubber, vulcanized or thermoplastic - Determination of hardness (hardness between 10 IRHD and 100 IRHD)

2014 ISO 3302-1:2014 Rubber - Tolerances for products - Part 1: Dimensional tolerances
2001 ISO 3302-1:1996/Amd 1:2001 Rubber - Tolerances for products - Part 1: Dimensional tolerances; Amendment 1: Classification system for flash
1996 ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances