EN 10149-2:2013 Hot rolled flat products made of high yield strength steels for cold forming - Part 2: Technical delivery conditions for thermomechanically rolled steels
This European Standard, in addition to EN 10149-1, specifies requirements for flat products made of weldable, hot-rolled, high yield strength steels for cold forming. The grades are given in Table 1 (chemical composition) and Table 2 (mechanical properties) and are supplied in the thermomechanically rolled delivery condition as given in 7.2. The steels specified in this European Standard are applicable to hot-rolled flat products in the thickness range of: 1,5 mm to 20 mm for the steels which have a specified minimum yield strength of 315 MPa1) up to and including 460 MPa 1); 1,5 mm to 16 mm for the steels which have a specified minimum yield strength of 500 MPa 1) up to and including 700 MPa 1); and from 2 mm up to 10 mm for the steels with a minimum yield stress in the range from 900 MPa 1) to 960 MPa 1) .
EN 10149-2:2013 Referenced Document
EN 10029:2010 Hot-rolled steel plates 3 mm thick or above - Tolerances on dimensions and shape*， 2024-04-20 Update
EN 10051:2010 Continuously hot-rolled strip and plate/sheet cut from wide strip of non-alloy and alloy steels - Tolerances on dimensions and shape*， 2024-04-20 Update
EN 10149-1:2013 Hot rolled flat products made of high yield strength steels for cold forming - Part 1: General technical delivery conditions
EN ISO 14713-2:2009 Zinc coatings - Guidelines and recommendations for the protection against corrosion of iron and steel in structures - Part 2: Hot dip galvanizing (ISO 14713-2:2009)*， 2024-04-20 Update
EN 10149-2:2013 history
2013EN 10149-2:2013 Hot rolled flat products made of high yield strength steels for cold forming - Part 2: Technical delivery conditions for thermomechanically rolled steels
1995EN 10149-2:1995 Hot-Rolled Flat Products Made of High Yield Strength Steels for Cold Forming - Part 2: Delivery Conditions for Thermomechanically Rolled Steels