ASTM F2762-11e1 PDF

Scope: 1.1 This specification covers requirements and test methods for annular, corrugated profile wall polyethylene pipe and fittings with an interior liner. The nominal inside diameters covered are 12 to 30 in. (300 to 750 mm).

1.2 The requirements of this specification are intended to provide pipe and fittings suitable for underground use for non-pressure sanitary sewer systems. Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321.

1.3 This specification covers pipe and fittings with an interior liner using a corrugated exterior profile (Fig. 1).

FIG. 1 Typical Annular Corrugated Pipe Profile

1.4 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F2762-11e1 Referenced Document

ASTM A666 Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
ASTM D2122 Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
ASTM D2321 Recommended Practice for Underground Installation Of Flexible Thermoplastic Sewer Pipe
ASTM D2412 Standard Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading
ASTM D2444 Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D3212 Standard Specification for Joints for Drain and Sewer Plastic Pipes Using Flexible Elastomeric Seals
ASTM D3350 Standard Specification for Polyethylene Plastics Pipe and Fittings Materials*， 2024-04-20 Update
ASTM D4389 Standard Specification for Finished Glass Fabrics Woven From Rovings
ASTM D618 Standard Practice for Conditioning Plastics for Testing
ASTM F2136 Standard Test Method for Notched, Constant Ligament-Stress (NCLS) Test to Determine Slow-Crack-Growth Resistance of HDPE Resins or HDPE Corrugated Pipe
ASTM F412 Standard Terminology Relating to Plastic Piping Systems
ASTM F477 Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe

2011 ASTM F2762-11e1 Standard Specification for 12 to 30 in. lpar;300 to 750 mmrpar; Annular Corrugated Profile-Wall Polyethylene lpar;PErpar; Pipe and Fittings for Sanitary Sewer Applications
2011 ASTM F2762-11 Standard Specification for 12 to 30 in. [300 to 750 mm] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Sanitary Sewer Applications