ASTM D4819-13 PDF

Scope: 1.1 This specification applies to flexible closed-cell materials made from polyolefin plastics and blends of polyolefin plastics as defined in Section 3.

1.2 Extruded or molded shapes too small to permit the cutting of standard test specimens are difficult to classify or test by standard test methods and will usually require special testing procedures or the use of standard test sheets.

1.3 In case of conflict between the provisions of this specification and those of detailed specifications for a particular product, the latter shall take precedence. These detailed specifications for the flexible closed-cell polyolefin plastic foams shall state the particular test or tests desired.

1.4 In cases involving referee decisions, SI units shall be used.

1.5 This specification does not contain test procedures or values for all the suffix letters listed in Table 1 and Table 2. Where the procedure is not described in this specification or special limits are desired, or both, the test procedures and values must be arranged between the purchaser and the supplier.

1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Note 1—There is no known ISO equivalent to this standard.

ASTM D4819-13 Referenced Document

ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
ASTM D1596 Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
ASTM D2863 Standard Test Method for Measuring the Minimum Oxygen Concentration to Support Candle-like Combustion of Plastics (Oxygen Index)
ASTM D3575 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
ASTM D412 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers8212;Tension
ASTM D624 Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
ASTM E96/E96M Standard Test Methods for Gravimetric Determination of Water Vapor Transmission Rate of Materials
ASTM F355 Standard Test Method for Shock-Absorbing Properties of Playing Surface Systems and Materials

2021 ASTM D4819-13(2021)e1 Standard Specification for Flexible Cellular Materials Made From Polyolefin Plastics
2013 ASTM D4819-13 Standard Specification for Flexible Cellular Materials Made From Polyolefin Plastics
1996 ASTM D4819-96(2005) Standard Specification for Flexible Cellular Materials Made From Polyolefin Plastics
1996 ASTM D4819-96 Standard Specification for Flexible Cellular Materials Made From Polyolefin Plastics