ASTM D7003/D7003M-03(2013)e1
Standard Test Method for Strip Tensile Properties of Reinforced Geomembranes

Standard No.
ASTM D7003/D7003M-03(2013)e1
Release Date
2003
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D7003/D7003M-03(2021)
Latest
ASTM D7003/D7003M-03(2021)
Scope

4.1 This test method evaluates strip tensile properties of reinforced geomembranes for the purposes of quality control, quality assurance and research. In order to evaluate the full contribution of the reinforcement, testing is performed parallel to the directions of reinforcement. This test method is an index test and is not intended for design purposes.

1.1 This test method is used to measure the strip tensile properties of reinforced geomembranes.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D7003/D7003M-03(2013)e1 Referenced Document

  • ASTM D4354 Standard Practice for Sampling of Geosynthetics for Testing
  • ASTM D4439 Standard Terminology for Geosynthetics
  • ASTM D76/D76M Standard Specification for Tensile Testing Machines for Textiles

ASTM D7003/D7003M-03(2013)e1 history

Standard Test Method for Strip Tensile Properties of Reinforced Geomembranes


Copyright ©2024 All Rights Reserved