International Organization for Standardization (ISO)
Latest
ISO 2982-2:2013
Scope
This part of ISO 2982 specifies:
— dimensions of locknuts;
— runout tolerance of locknut clamp face with respect to pitch diameter of screw thread;
— dimensions of lockwashers with straight inner tab for use with 4-slot locknuts;
— dimensions of locking clip assemblies for use with 8-slot locknuts.
The locknuts are also suitable for axial location of bearing inner rings on shafts and for dismounting of withdrawal sleeves.
For adapter sleeve assemblies and withdrawal sleeves, see ISO 2982-1.
ISO 2982-2:2013 Referenced Document
ISO 15241 Rolling bearings — Symbols for physical quantities — Amendment 1*, 2020-01-08 Update
ISO 5593 Rolling bearings — Vocabulary*, 2023-02-28 Update
ISO 2982-2:2013 history
2013ISO 2982-2:2013 Rolling bearings - Accessories - Part 2: Dimensions for locknuts and locking devices
2001ISO 2982-2:2001 Rolling bearings - Accessories - Part 2: Locknuts and locking devices; Dimensions
1995ISO 2982-2:1995 Rolling bearings - Accessories - Part 2: Locknuts and locking devices - Dimensions