ASTM E864-12 PDF

Scope: 4.1 Durable adhesive bonds to aluminum alloys can be obtained reliably only through proper selection and careful control of the materials used and the steps in the bonding process. The preparation of the aluminum alloys to obtain clean, uniform surfaces with appropriate characteristics is a critical step. This practice describes how such surfaces can be obtained.

1.1 This practice covers the preparation of clean uniform surfaces of aluminum alloys suitable for formation of durable adhesive bonds to nonmetallic honeycomb materials in the manufacture of sandwich panels for tactical shelters.

1.2 The values stated in SI units are to be regarded as the standard where only SI units are given or where SI units are given first followed by inch-pound units; where inch-pound units are given first followed by SI units, the inch-pound units are to regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see 6.2.1.

ASTM E864-12 Referenced Document

ASTM D2674 Standard Methods of Analysis of Sulfochromate Etch Solution Used in Surface Preparation of Aluminum
ASTM D3167 Standard Test Method for Floating Roller Peel Resistance of Adhesives
ASTM E1749 Standard Terminology Relating to Rigid Wall Relocatable Shelters
ASTM E631 Standard Terminology of Building Constructions
ASTM E865 Standard Specification for Structural Film Adhesives for Honeycomb Sandwich Panels
ASTM E866 Standard Specification for Corrosion-Inhibiting Adhesive Primer for Aluminum Alloys to Be Adhesively Bonded in Honeycomb Shelter Panels

2020 ASTM E864-20 Standard Practice for Surface Preparation of Aluminum Alloys to Be Adhesively Bonded in Honeycomb Shelter Panels
2012 ASTM E864-12 Standard Practice for Surface Preparation of Aluminum Alloys to Be Adhesively Bonded in Honeycomb Shelter Panels
2008 ASTM E864-08 Standard Practice for Surface Preparation of Aluminum Alloys to be Adhesively Bonded in Honeycomb Shelter Panels
2003 ASTM E864-03 Standard Practice for Surface Preparation of Aluminum Alloys to be Adhesively Bonded in Honeycomb Shelter Panels
1998 ASTM E864-98e1 Standard Practice for Surface Preparation of Aluminum Alloys to be Adhesively Bonded in Honeycomb Shelter Panels
1998 ASTM E864-98 Standard Practice for Surface Preparation of Aluminum Alloys to be Adhesively Bonded in Honeycomb Shelter Panels