ASTM C418-12
Standard Test Method for Abrasion Resistance of Concrete by Sandblasting
- Standard No.
- ASTM C418-12
- Release Date
- 2012
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM C418-20
- Latest
- ASTM C418-20
- Scope
- 1.1 This test method covers determination of the abrasion resistance characteristics of concrete by subjecting it to the impingement of air-driven silica sand. It is intended for use as a basis for the development of informed judgment.
1.2 The values stated in SI units are to be regarded as the standard. Inch-pound units are shown for information purposes in parentheses.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1???Users of this test method are advised that there are known safety hazards associated with the use of silica as a blasting media. Consult the silica manufactures MSDS to insure that the latest recommended health and safety practices are being followed.
Note 2???Other procedures are available for measuring abrasion resistance of concrete surfaces in addition to subjecting it to air driven silica sand. Consideration should be given to other methods of testing as outlined in ASTM C779/C779M, ASTM C944, and ASTM C1138. The test method most closely representing service conditions should be used.
1.4 The text of this standard references notes and footnotes which are provided as explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.
ASTM C418-12 Referenced Document
- ASTM C1138 Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)
- ASTM C125 Standard Terminology Relating to Concrete and Concrete Aggregates
- ASTM C127 Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Coarse Aggregate
- ASTM C778 Standard Specification for Standard Sand
- ASTM C779/C779M Standard Test Method for Abrasion Resistance of Horizontal Concrete Surfaces
- ASTM C944 Standard Test Method for Abrasion Resistance of Concrete or Mortar Surfaces by the Rotating-Cutter Method
ASTM C418-12 history
- 2020 ASTM C418-20 Standard Test Method for Abrasion Resistance of Concrete by Sandblasting
- 2012 ASTM C418-12 Standard Test Method for Abrasion Resistance of Concrete by Sandblasting
- 2005 ASTM C418-05 Standard Test Method for Abrasion Resistance of Concrete by Sandblasting
- 1998 ASTM C418-98 Standard Test Method for Abrasion Resistance of Concrete by Sandblasting
