ASTM D5206-13
Standard Test Method for Windload Resistance of Rigid Plastic Siding

Standard No.

ASTM D5206-13

Release Date

2013

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5206-19

Latest

ASTM D5206-19

Scope

5.1 This test method is a standard procedure for determining windload resistance of rigid plastic siding under specified uniform static pressure difference. This typically is intended to represent the effects of wind loads on exterior building surfaces. The actual loading on building surfaces is quite complex, varying with wind direction, time, height above ground, building shape, terrain, surrounding structures, and other factors.

5.2 Design wind pressure is selected for specific geographical locations from wind velocity maps prepared by the National Weather Service or other sources. Refer to Annex A1 of Specification D3679 for additional detailed information relating to use of this test method for evaluation of rigid poly(vinyl chloride) (PVC) siding.

Note 2???In applying the results of this test method, note that the performance of rigid PVC siding is a function of installation, and the specimen may or may not truly represent the actual application. In service, performance will also depend on the rigidity of supporting construction, and on the resistance of other components to deterioration by various causes, to thermal expansion and contraction, etc.

1.1 This test method describes methods for testing and evaluating windload resistance of rigid plastic siding when fastened in accordance with Practice D4756.

1.2 The proper use of this test method requires a knowledge of the principles of pressure measurement.

1.3 This test method describes the apparatus and the procedures to be used to determine an average maximum sustained static test pressure, or ultimate test pressure values, or both, with static pressure applied uniformly to a specimen.

Note 1???There is no known ISO equivalent to this test method.

1.4 The values expressed in inch-pound units are to be regarded as the standard. The SI equivalents in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.

ASTM D5206-13 Referenced Document

• ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
• ASTM D3679 Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Siding
• ASTM D4756 Standard Practice for Installation of Rigid Poly(Vinyl Chloride) (PVC) Siding and Soffit
• ASTM D883 Standard Terminology Relating to Plastics
• ASTM E631 Standard Terminology of Building Constructions

ASTM D5206-13 history

• 2019 ASTM D5206-19 Standard Test Method for Windload Resistance of Rigid Plastic Siding
• 2013 ASTM D5206-13 Standard Test Method for Windload Resistance of Rigid Plastic Siding
• 2006 ASTM D5206-06a Standard Test Method for Windload Resistance of Rigid Plastic Siding
• 1996 ASTM D5206-96(2002)e1 Standard Test Method for Windload Resistance of Rigid Poly(Vinyl Chloride) (PVC) Siding
• 1996 ASTM D5206-96 Standard Test Method for Windload Resistance of Rigid Poly(Vinyl Chloride) (PVC) Siding