ASTM F2882-12 PDF

Scope: 1.1 This specification covers the requirements for quenched and tempered alloy steel screws 0.060 through 1¹/₂ inches in diameter having a minimum ultimate tensile strength of 170 KSI.
Note 1???This specification is the inch companion of Specification F2882M.

1.2 The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F2882-12 Referenced Document

ASTM A751 Standard Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
ASTM E112 Standard Test Methods for Determining Average Grain Size
ASTM F1470 Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
ASTM F1940 Standard Test Method for Process Control Verification to Prevent Hydrogen Embrittlement in Plated or Coated Fasteners
ASTM F2282 Standard Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners
ASTM F2328 Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts
ASTM F606 Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets
ASTM F788/F788M Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series

2017 ASTM F2882/F2882M-17 Standard Specification for Screws, Alloy Steel, Heat Treated, 170 ksi and 1170 MPa Minimum Tensile Strength (Inch and Metric)
2012 ASTM F2882-12 Standard Specification for Screws, Alloy Steel, Heat Treated, 170 ksi Minimum Tensile Strength