This European Standard specifies:the dimensional, leaktightness, mechanical, hydraulic and acoustic characteristics with which extractable outlets with or without spray mode selector function need to comply; the procedures for testing these characteristics.It applies to extractable outlets made from any material which is intended for equipping and supplementing sanitary tapware for sinks and wash-basins used for culinary or ablutionary purposes. Such extractable outlets shall only be connected downstream of the obturator of the tapware. Extractable outlets with total closing device fitted after the obturator of the tapware are not covered by this standard.
EN 16145:2012 Referenced Document
EN 16146:2012 Sanitary tapware - Extractable shower hoses for sanitary tapware for supply systems type 1 and type 2 - General technical specification (Incorporates Amendment A1: 2014)
EN 1717:2000 Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow
EN 248:2002 Sanitary tapware - General specification for electrodeposited coatings of Ni-Cr
EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation ISO 228-1: 2000
EN ISO 3822-1:1999 Acoustics ?Laboratory tests on noise emission from appliances and equipment used in water supply installations ?Part 1: Method of measurement Incorporates Amendment A1: 2008
EN ISO 3822-4:1997 Acoustics - Laboratory Tests on Noise Emission from Appliances and Equipment Used in Water Supply Installations - Part 4: Mounting and Operating Conditions for Special Appliances
EN 16145:2012 history
2012EN 16145:2012 Sanitary tapware - Extractable outlets for sink and basin mixers - General technical specification