DS/EN 754-7:2008
Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form

Standard No.

DS/EN 754-7:2008

Release Date

2008

Published By

Danish Standards Foundation

Latest

DS/EN 754-7:2008

Replace

DS/EN 754-7-2000

Scope

This document specifies the tolerances on dimensions and form for aluminium and aluminium alloys cold drawn seamless tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2) supplied in straight lengths.This standard only applies to tube produced by the seamless die/mandrel method of extrusion (and then cold drawn to the final dimensions required).The temper designations used in this part are according to EN 515.This document applies to cold drawn, seamless tube for general engineering applications.This do

DS/EN 754-7:2008 history

• 2008 DS/EN 754-7:2008 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form