DS/IEC/TS 60695-11-3:2004
Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods

Standard No.

DS/IEC/TS 60695-11-3:2004

Release Date

2004

Published By

Danish Standards Foundation

Status

Be replaced 2012-12

Replace By

DS/EN 60695-11-3:2012

Latest

DS/EN 60695-11-3:2012

Replace

DS/ENV 60695-2-4/2:1996 DS/IEC 695-2-4/0:1993

Scope

This technical specification provides detailed requirements for the production of a 500 W nominal, pre-mixed type test flame. The approximate overall height is 125 mm. Two test flames are described: Method A may only be produced using methane, whereas method C may be produced using either methane or propane. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

DS/IEC/TS 60695-11-3:2004 history

• 2012 DS/EN 60695-11-3:2012 Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods
• 2004 DS/IEC/TS 60695-11-3:2004 Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods
• 1999 DS/EN 60695-11-10:1999 Fire hazard testing - Part 11-10: Test flames - 50W horizontal and vertical flame test methods
• 0000 DS/ENV 60695-2-4/2:1996
• 1993 DS/IEC 695-2-4/0:1993 Fire hazard testing. Part 2: Test methods. Section 4/sheet 0: Diffusion type and premixed type flame test methods

DS/IEC/TS 60695-11-3:2004 Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods has been changed from DS/IEC 695-2-4/0:1993 Fire hazard testing. Part 2: Test methods. Section 4/sheet 0: Diffusion type and premixed type flame test methods.

DS/IEC/TS 60695-11-3:2004 Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods was changed to DS/EN 60695-11-3:2012 Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods.