DS/EN 60034-14:2004
Rotating electrical machines - Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher - Measurement, evaluation and limits of vibration severity

Standard No.

DS/EN 60034-14:2004

Release Date

2004

Published By

Danish Standards Foundation

Status

Be replaced 2007-11

Replace By

DS/EN 60034-14/A1:2007

Latest

DS/EN 60034-14/A1:2007

Replace

DS/EN 60034-14-1999

Scope

This part of IEC 60034 specifies the factory acceptance vibration test procedures and vibration limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover. It is applicable to d.c. and three-phase a.c. machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at operational speeds from 120 min up to and including 15 000/min. This standard is not applicable to machines mounted in situ, three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical waterpower generators, turbine generators greater than 20 MW and machines with magnetic

DS/EN 60034-14:2004 history

• 2007 DS/EN 60034-14/A1:2007 Rotating electrical machines - Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher - Measurement, evaluation and limits of vibration severity
• 2004 DS/EN 60034-14:2004 Rotating electrical machines - Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher - Measurement, evaluation and limits of vibration severity