DS/ISO 11414:2009
Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion

Standard No.

DS/ISO 11414:2009

Release Date

2009

Published By

Danish Standards Foundation

Latest

DS/ISO 11414:2009

Scope

This International Standard specifies a method for preparing butt-fusion-jointed test piece assemblies between polyethylene (PE) pipes and spigot-ended fittings.It specifies the assembly parameters involved, such as the ambient temperature, joint geometry andfusion parameters, taking into account the service condition limits specified in the relevant product standards, as well as the type of pipe to be used.This International Standard is intended to enable the effect of site assembly variables on joint performance to be determined. The fusion-jointing procedures and parameters used in the field can differ from those in this document, depending on the manufa

DS/ISO 11414:2009 history

• 2009 DS/ISO 11414:2009 Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion