BS EN 60939-2:2005 PDF

Scope: This Sectional specification applies to passive filter units for electromagnetic interference suppression which fall within the scope of the Generic Specification IEC 60939-1. The scope of this Sectional specification is restricted to passive filter units for which safety tests are appropriate. This implies that filters specified according to this Sectional specification will either be connected to mains supplies, when compliance with the mandatory tests of Table 3 is necessary, or used in other circuit positions where the equipment specification prescribes that some or all of these safety tests are required. This Sectional specification applies to passive filter units which will be connected to an a.c. mains or other supply with a nominal voltage not exceeding 1 000 V a.c, with a nominal frequency not exceeding 400 Hz, or 1 000 V d.c.

BS EN 60939-2:2005 Referenced Document

IEC 60060-1 High-voltage test techniques - Part 1: General definitions and test requirements*， 2010-09-01 Update
IEC 60062 Marking codes for resistors and capacitors CONSOLIDATED EDITION*， 2019-08-20 Update
IEC 60068-1 Environmental testing - Part 1: General and guidance*， 2013-10-01 Update
IEC 60085 Electrical insulation - Thermal evaluation and designation*， 2007-11-01 Update

2023 BS EN 60939-2:2005+A1:2023 Passive filter units for electromagnetic interference suppression. Sectional specification. Passive filter units for which safety tests are appropriate. Test methods and general requirements
0000 BS EN 60939-2:2005(2006)
2005 BS EN 60939-2:2005 Passive filter units for electromagnetic interference suppression - Sectional specification: passive filter units for which safety tests are appropriate - Test methods and general requirements