1.1 This specification covers UNS N08925, UNS N08354, and UNS N08926 welded pipe for general corrosion applications.
1.2 This specification covers pipe sizes in schedules shown in Table 1.
1.3 ASTM International has adopted definitions whereby some grades, such as UNS N08904, previously in this specification were recognized as stainless steels, because those grades have iron as the largest element by mass percent. Such grades are under the oversight of ASTM Committee A01 and its subcommittees. The products of N08904 previously covered in this specification are now covered by Specification A312/A312M.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
TABLE 1 Dimensions of Welded Pipe
Note 18212;The following table is a partial reprint of Table 1 of ANSI B36.19.
Note 28212;The decimal thicknesses listed for the respective pipe sizes represent their nominal wall dimensions.
Note 38212;1 in. = 25.4 mm.
| Nominal Pipe Size, in. | Outside Diameter | Nominal Wall Thickness, in. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Schedule | 5SA | Schedule | 10SA | Schedule | 40S | Schedule | 80S | Schedule | 160S | |||
| 1/8 | 0.405 | 10.29 | ... | ... | 0.049 | 1.25 | 0.068 | 1.73 | 0.095 | 2.41 | ... | ... |
| 1/4 | 0.540 | 13.72 | ... | ... | 0.065 | 1.65 | ||||||