ASTM D3813/D3813M-98(2012)e1
Standard Test Method for Curling, Twisting, and Tubing on Unwind of Pressure-Sensitive Tapes

Standard No.
ASTM D3813/D3813M-98(2012)e1
Release Date
1998
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D3813/D3813M-98(2020)
Latest
ASTM D3813/D3813M-98(2020)
Scope

This test method will provide information on the relative tendency of tapes to curl, twist, or form into a tube with touching edges. The amount of each is a predictor of the difficulty one might experience in handling strips of tape of any length during their application.

There are several causes for variation in the extent or degree of these characteristics and may vary themselves within a production lot of tape. Therefore, it is essential to use an accepted sampling plan (see Section 7) when it is desired to use this test method to compare two types of tape for acceptance sampling purposes.

1.1 This test method provides one procedure for determining the extent of curling, the degree of twisting, and tendency to form a tube resulting from unwinding of the tape from its roll.

1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D3813/D3813M-98(2012)e1 Referenced Document

  • ASTM D3715/D3715M Standard Practice for Quality Assurance of Pressure-Sensitive Tapes*， 2019-08-01 Update
  • ASTM D4332 Standard Practice for Conditioning Containers, Packages, or Packaging Components for Testing*， 1999-04-19 Update
  • ASTM D996 Standard Terminology of Packaging and Distribution Environments*， 1999-04-19 Update
  • ASTM E122 Standard Practice for Calculating Sample Size to Estimate, With a Specified Tolerable Error, the Average for Characteristic of a Lot or Process*， 2000-10-10 Update

ASTM D3813/D3813M-98(2012)e1 history

Standard Test Method for Curling, Twisting, and Tubing on Unwind of Pressure-Sensitive Tapes


Copyright ©2024 All Rights Reserved