EN ISO 14405-2:2011
Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear sizes
- Standard No.
- EN ISO 14405-2:2011
- Release Date
- 2011
- Published By
- European Committee for Standardization (CEN)
- Status
- 2019-01
- Replace By
- EN ISO 14405-2:2019
- Latest
- EN ISO 14405-2:2019
- Replace
- FprEN ISO 14405-2:2011
- Scope
- This part of ISO 14405 illustrates the use of geometrical tolerancing for dimensions that are not linear sizes toavoid the ambiguity that the use of ？ tolerances on these dimensions causes. Both linear and angulardimensions, except size of features of size are covered.
EN ISO 14405-2:2011 Referenced Document
- ISO 1101 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
- ISO 129-1 Technical product documentation (TPD) — Presentation of dimensions and tolerances — Part 1: General principles — Amendment 1
- ISO 13715:2000 Technical drawings - Edges of undefined shape - Vocabulary and indications
- ISO 14405-1:2010 Geometrical product specifications (GPS) - Dimensional tolerancing - Part 1: Linear sizes
- ISO 14660-1:1999 Geometrical Product Specifications (GPS) - Geometrical features - Part 1: General terms and definitions
- ISO 14660-2:1999 Geometrical Product Specifications (GPS) - Geometrical features - Part 2: Extracted median line of a cylinder and a cone, extracted median surface, local size of an extracted feature
- ISO 17450-1 Geometrical product specifications (GPS) - General concepts - Part 1: Model for geometrical specification and verification
- ISO 17450-2 Geometrical product specifications (GPS) - General concepts - Part 2: Basic tenets, specifications, operators, uncertainties and ambiguities
- ISO 2538:1998 Geometrical Product Specifications (GPS) - Series of angles and slopes on prisms
- ISO 286-1 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits; Technical Corrigendum 1
- ISO 8015:2011 Geometrical product specifications (GPS) - Fundamentals - Concepts, principles and rules
EN ISO 14405-2:2011 history
- 2019 EN ISO 14405-2:2019 Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear or angular sizes
- 2011 EN ISO 14405-2:2011 Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear sizes
