ASTM D5947-11
Standard Test Methods for Physical Dimensions of Solid Plastics Specimens

Standard No.

ASTM D5947-11

Release Date

2011

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5947-18

Latest

ASTM D5947-18

Scope

These test methods shall be used where precise dimensions are necessary for the calculation of properties expressed in physical units. They are not intended to replace practical thickness measurements based on commercial portable tools, nor is it implied that thickness measurements made by the procedures will agree exactly.

1.1 These test methods cover determination of the physical dimensions of solid plastic specimens where the dimensions are used directly in determining the results of tests for various properties. Use these test methods except as otherwise required in material specifications.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 18212;This standard and ISO 16012 address the same subject matter, but differ in technical content.

ASTM D5947-11 Referenced Document

• ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-19 Update
• ASTM D618 Standard Practice for Conditioning Plastics for Testing
• ASTM D638 Standard Test Method for Tensile Properties of Plastics
• ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-19 Update
• ASTM D883 Standard Terminology Relating to Plastics
• ISO 16012 Plastics - Determination of linear dimensions of test specimens
• ISO 472 Plastics — Vocabulary — Amendment 1: Additional items

ASTM D5947-11 history

• 2018 ASTM D5947-18 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 2011 ASTM D5947-11 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 2006 ASTM D5947-06 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 2003 ASTM D5947-03 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 2002 ASTM D5947-02 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 2001 ASTM D5947-01e1 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
• 1996 ASTM D5947-96 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens