ASTM D5449/D5449M-11
Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders

Standard No.

ASTM D5449/D5449M-11

Release Date

2011

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5449/D5449M-16

Latest

ASTM D5449/D5449M-22

Scope

This test method is designed to produce transverse compressive property data for material specifications, research and development, quality assurance, and structural design and analysis. Factors that influence the transverse compressive response and should therefore be reported are: material, method of material preparation, specimen preparation, specimen conditioning, environment of testing, specimen alignment and gripping, speed of testing, void content, and fiber volume fraction. Properties in the test direction that may be obtained from this test method are:

5.1.1 Transverse compressive strength, σ₂₂^uc,

5.1.2 Transverse compressive strain at failure, ε₂₂^uc,

5.1.3 Transverse compressive modulus of elasticity, E₂₂, and

5.1.4 Poissonrsquo;ratio, γ₂₁.

1.1 This test method determines the transverse compressive properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90) cylinders in axial compression for determination of transverse compressive properties.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5449/D5449M-11 history

• 2022 ASTM D5449/D5449M-22 Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2016 ASTM D5449/D5449M-16 Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2011 ASTM D5449/D5449M-11 Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2006 ASTM D5449/D5449M-93(2006) Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 1993 ASTM D5449/D5449M-93(2000) Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2001 ASTM D5449/D5449M-93 Standard Test Method for Transverse Compressive Properties of Hoop Wound Polymer Matrix Composite Cylinders