DIN ISO 11901-1:2005
Tools for pressing - Gas springs - Part 1: General specifications (ISO 11901-1:2003)

Standard No.

DIN ISO 11901-1:2005

Release Date

2005

Published By

German Institute for Standardization

Status

Be replaced

Replace By

DIN ISO 11901-1:2005-09

Latest

DIN ISO 11901-1:2005-09

Replace

DIN ISO 11901-1:2004 DIN ISO 11901-1:1996

Scope

This part of ISO 11901 specifies the dimensions, in millimetres, nominal initial forces and type of gas springs. It applies to gas springs of type 900 to 100000, pressurized with nitrogen with a nominal initial force between 900 N ?5 % and 100600 N ?5 %, for use in press tools. It also specifies marking, technical delivery conditions and designation.

DIN ISO 11901-1:2005 Referenced Document

• ISO 2768-1 General tolerances; part 1: tolerances for linear and angular dimensions without individual tolerance indications
• ISO 7-1 Pipe threads where pressure-tight joints are made on the threads — Part 1: Dimensions, tolerances and designation TECHNICAL CORRIGENDUM 1

DIN ISO 11901-1:2005 history

• 2005 DIN ISO 11901-1:2005-09 Tools for pressing - Gas springs - Part 1: General specifications (ISO 11901-1:2003)
• 2005 DIN ISO 11901-1:2005 Tools for pressing - Gas springs - Part 1: General specifications (ISO 11901-1:2003)
• 0000 DIN ISO 11901-1:2004
• 0000 DIN ISO 11901-1:1996