DIN ISO 11901-2:2005
Tools for pressing - Gas springs - Part 2: Specification of accessories (ISO 11901-2:2004)
- Standard No.
- DIN ISO 11901-2:2005
- Release Date
- 2005
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN ISO 11901-2 E:2018
- Latest
- DIN ISO 11901-2:2019-06
- Replace
- DIN ISO 11901-2:2004 DIN ISO 11901-2:1996
- Scope
- This part of ISO 11901 specifies the dimensions, in millimetres, of mounting base plates, of two-part mounting clamps, of flange mounts and of front end supports intended for use in press tools together with gas springs in accordance with ISO 11901-1. It also gives information concerning materials and specifies the designation of the mounting accessories in accordance with this part of ISO 11901.
DIN ISO 11901-2:2005 Referenced Document
- ISO 11901-1 Tools for pressing - Gas springs - Part 1: General specifications
- ISO 2768-1 General tolerances; part 1: tolerances for linear and angular dimensions without individual tolerance indications
- ISO 630 Structural steels — Plates, wide flats, bars, sections and profiles — Amendment 1
DIN ISO 11901-2:2005 history
- 2019 DIN ISO 11901-2:2019-06 Tools for pressing - Gas springs - Part 2: Specification of accessories (ISO 11901-2:2018)
- 2019 DIN ISO 11901-2:2019 Tools for pressing - Gas springs - Part 2: Specification of accessories (ISO 11901-2:2018)
- 1970 DIN ISO 11901-2 E:2018-10 Tools for pressing - Gas springs - Part 2: Specification of accessories
- 2018 DIN ISO 11901-2 E:2018 Draft Document - Tools for pressing - Gas springs - Part 2: Specification of accessories (ISO/FDIS 11901-2:2018); Text in German and English
- 2005 DIN ISO 11901-2:2005 Tools for pressing - Gas springs - Part 2: Specification of accessories (ISO 11901-2:2004)
- 0000 DIN ISO 11901-2:2004
- 0000 DIN ISO 11901-2:1996
