This standard stipulates that the maximum working pressure shall not exceed 50 kPa, the maximum flow rate shall not exceed 160 m3/h, the minimum working environment temperature range shall be -10 °C to + 40 °C, and the working medium temperature range shall not be less than 40 K. The technical requirements and test methods for the structure, performance, safety and other aspects of the 1.5-level diaphragm gas meter with pipe or single pipe joint (hereinafter referred to as gas meter). This standard applies to gas meters installed in closed places (indoors or outdoors with protective measures) or open places (outdoors without any protective measures) with or without slight vibration, shock, condensed water and electromagnetic interference [including the installation of electronic auxiliary device (see appendix C), gas meter with built-in mechanical gas temperature conversion device (see appendix D)]. Unless otherwise specified, the pressure mentioned in this standard refers to relative atmospheric pressure (gauge pressure).
GB 3836.2-2010 Explosive atmospheres.Part 2:Equipment protection by flameproof enclosures "d"
GB 3836.4-2010 Explosive atmospheres.Part 4:Equipment protection by intrinsic safety "i"
GB 4208-2008 Degrees of protection provided by enclosure(IP code)
GB 5080.7-1986 The verification test plan of failure rate and mean time between failures under the assumption of constant failure rate in equipment reliability test
GB/T 11 Countersunk head nib bolts*, 2013-06-09 Update
GB/T 1771-2007 Paints and varnishes.Determination of resistance to neutral salt spray(fog)
GB/T 191-2008 Packaging.Pictorial marking for handling of goods
GB/T 2410-2008 Determination of light transmittance and haze of transparent plastics
GB/T 2423.1-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Tests A:Cold
GB/T 2423.17-2008 Environmental testing for electric and electronic products.Part 2:Test method.Test Ka:Salt mist
GB/T 2423.2-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Tests B:Dry heat
GB/T 2423.3-2006 Environmental testing for electric and electronic products-Part 2:Tesing method-Test Cab:Damp heat,steady state
GB/T 9113.1-2000 Intergral steel pipe flanges with flat face or raised face