EN ISO 15530-3:2011
Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)

Standard No.

EN ISO 15530-3:2011

Release Date

2011

Published By

European Committee for Standardization (CEN)

Latest

EN ISO 15530-3:2011

Replace

CEN ISO/TS 15530-3:2007

Scope

This European Standard specifies a laboratory method to determine the leaching behaviour of substances from coatings into water over defined time intervals. The release of substances from coatings under natural conditions cannot be determined withThis method.

EN ISO 15530-3:2011 Referenced Document

• ISO 10360-1:2000 Geometrical Product Specifications (GPS) - Acceptance and reverification test for coordinate measuring machines (CMM) - Part 1: Vocabulary
• ISO 14978:2006 Geometrical product specifications (GPS) - General concepts and requirements for GPS measuring equipment
• ISO/IEC Guide 98-3:2008 Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)
• ISO/IEC Guide 99:2007 International vocabulary of metrology - Basic and general concepts and associated terms (VIM)

EN ISO 15530-3:2011 history

• 2011 EN ISO 15530-3:2011 Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)

EN ISO 15530-3:2011 Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011) has been changed from CEN ISO/TS 15530-3:2007 Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or standards.