BS 6001-1:1999+A1:2011
Sampling procedures for inspection by attributes. Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection

Standard No.

BS 6001-1:1999+A1:2011

Release Date

1999

Published By

British Standards Institution (BSI)

Latest

BS 6001-1:1999+A1:2011

Replace

94/408416 DC-1994 BS 6001-1:1991 BS 6001-1:1999

Scope

1.1 This part of ISO 2859 specifies an acceptance sampling system for inspection by attributes. It is indexed in terms of the acceptance quality limit (AQL). Its purpose is to induce a supplier through the economic and psychological pressure of lot non-acceptance to maintain a process average at least as good as the specified acceptance quality limit, while at the same time providing an upper limit for the risk to the consumer of accepting the occasional poor lot. Sampling schemes designated in this part of ISO 2859 are applicable, but not limited, to inspection of - end items, - components and raw materials, - operations, - materials in process, - supplies in storage, - maintenance operations, - data or records, and - administrative procedures. 1.2 These schemes are intended primarily to be used for a continuing series of lots, that is, a series long enough to allow the switching rules (9.3) to be applied. These rules provide: a) a protection to the consumer (by means of a switch to tightened inspection or discontinuation of sampling inspection) should a deterioration in quality be detected; b) an incentive (at the discretion of the responsible authority) to reduce inspection costs (by means of a switch to reduced inspection) should consistently good quality be achieved. Sampling plans in this part of ISO 2859 may also be used for the inspection of lots in isolation but, in this case the user is strongly advised to consult the operating characteristic curves to find a plan that will yield the desired protection (see 12.6). In that case, the user is also referred to the sampling plans indexed by limiting quality (LQ) given in ISO 2859-2.

BS 6001-1:1999+A1:2011 Referenced Document

• ISO 2859-3 Sampling procedures for inspection by attributes - Part 3: Skip-lot sampling procedures*， 2005-05-01 Update
• ISO 3534-1 Statistics — Vocabulary and symbols — Part 1: General statistical terms and terms used in probability
• ISO 3534-2 Statistics - Vocabulary and symbols - Part 2: Applied statistics*， 2006-09-01 Update

BS 6001-1:1999+A1:2011 history

• 1999 BS 6001-1:1999+A1:2011 Sampling procedures for inspection by attributes. Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
• 1999 BS 6001-1:1999 Sampling procedures for inspection by attributes - Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection