This part of EN 500 specifies the safety requirements for compaction machines as defined in Clause 3 and deals with all significant hazards, hazardous situations and events relevant to compaction machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable.
This document specifies additional requirements to and/or exceptions from EN 500-1 "Common requirements".
This part of EN 500 is not applicable for seated ride-on operated rollers with a drum width less than nominal 0,8 m.
DIN EN 500-4:2011 Referenced Document
EN 60204-1:2006 Safety of machinery - Electrical equipment of machines Part 1: General requirements (Incorporates Amendment A1: 2009; Incorporating corrigendum February 2010)
EN 60664 Insulation coordination for equipment within low-voltage systems - Part 5: Comprehensive method for determining clearances and creepage distances equal to or less than 2 mm*, 2024-04-19 Update
EN 954-1:1996 Safety of Machinery - Safety-Related Parts of Control Systems - Part 1: General Principles for Design
EN ISO 11201:2010 Acoustics - Noise emitted by machinery and equipment - Determination of emission sound pressure levels at a work station and at other specified positions in an essentially free field over a reflecting plane with negligible environmental corrections
EN ISO 12100:2010 Safety of machinery - General principles for design - Risk assessment and risk reduction (ISO 12100:2010)*, 2024-04-19 Update
EN ISO 20643:2008 Mechanical vibration - Hand-held and hand-guided machinery - Principles for evaluation of vibration emission (ISO 20643:2005)
EN ISO 3164:2008 Earth-moving machinery - Laboratory evaluations of protective structures - Specifications for deflection-limiting volume
EN ISO 3450:2008 Earth-moving machinery - Braking systems of rubber-tyred machines - Systems and performance requirements and test procedures
EN ISO 3471:2008 Earth-moving machinery - Roll-over protective structures - Laboratory tests and performance requirements (ISO 3471:2008)
EN ISO 3744:2010 Acoustics - Determination of sound power levels and sound energy levels of noise sources using sound pressure - Engineering methods for an essentially free field over a reflecting plane (ISO 3744:2010)*, 2024-04-19 Update
EN ISO 6683:2008 Earth-moving machinery - Seat belts and seat belt anchorages - Performance requirements and tests (ISO 6683:2005)
ISO 17063:2003 Earth-moving machinery - Braking systems of pedestrian-controlled machines - Performance requirements and test procedures
DIN EN 500-4:2011 history
2011DIN EN 500-4:2011-06 Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines; German version EN 500-4:2011 / Note: To be replaced by DIN EN ISO 20500-4 (2020-10).
2011DIN EN 500-4:2011 Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines; German version EN 500-4:2011
2010DIN EN 500-4:2010 Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines; German version EN 500-4:2006+A1:2009
2007DIN EN 500-4:2007 Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines; German version EN 500-4:2006
1995DIN EN 500-4:1996 Mobile road construction machinery, Safety — Part 4: Specific requirements for compaction machines
DIN EN 500-4:2011 Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines; German version EN 500-4:2011 was changed to ANSI/UL 60079-11-2013 Standard for Safety for Explosive Atmospheres - Part 11: Equipment Protection by Intrinsic Safety i (Proposal Ballot dated 06-29-12).