BS EN 13341:2005
Thermoplastics static tanks for above ground storage of domestic heating oils, kerosene and diesel fuels - Blow moulded polyethylene, rotationally moulded polyethylene and polyamide 6 by anionic polymerization tanks - Requirements and test methods

Standard No.

BS EN 13341:2005

Release Date

2005

Published By

British Standards Institution (BSI)

Status

Be replaced 2005-04

Replace By

BS EN 13341:2005+A1:2011

Latest

BS EN 13341:2005+A1:2011

Scope

This document specifies requirements for materials, physical properties and performance of single blow moulded and rotationally moulded polyethylene tanks or polyamide 6 (by anionic polymerisation) tanks, with or without reinforcements, for above ground storage of domestic heating oil, kerosene and diesel fuels. It is only applicable to static blow moulded and rotationally moulded polyethylene tanks and polyamide 6 (by anionic polymerisation) tanks that are subject to atmospheric pressure and have a capacity from 450 l up to 10 000 l. This document does not consider the consequences of wind or snow loading which is considered to be an installation issue.

BS EN 13341:2005 history

• 2005 BS EN 13341:2005+A1:2011 Static thermoplastic tanks for above ground storage of domestic heating oils, kerosene and diesel fuels. Blow moulded and rotationally moulded polyethylene tanks and rotationally moulded tanks made of anionically polymerized polyamide 6. Requirements and
• 2005 BS EN 13341:2005 Thermoplastics static tanks for above ground storage of domestic heating oils, kerosene and diesel fuels - Blow moulded polyethylene, rotationally moulded polyethylene and polyamide 6 by anionic polymerization tanks - Requirements and test methods