ISO 4955:2005 PDF

Scope: 1 This International Standard specifies requirements for the grades of wrought steels, listed in Table 1, which are usually employed for products for which the resistance to the effects of hot gases and the products of combustion at temperatures in the region above 550 ℃ is the main requirement. 2 This International Standard is applicable to — flat products; — bars; — sections; — wire and rod; — forgings. NOTE 1 Heat-resisting steels for valves are covered by ISO 683-15. NOTE 2 Corrosion-resistant stainless steels for which resistance to corrosion is of primary importance are covered by ISO 16143-1, ISO 16143-2 and ISO 16143-3. NOTE 3 Not all of the steels included in this International Standard are necessarily available in all product forms. NOTE 4 Wire in the cold-worked condition is covered by ISO 16143-3. 3 In addition to this International Standard, the general technical delivery requirements of ISO 404 are applicable.

ISO 4955:2005 Referenced Document

ISO 10474:1991 Steel and steel products; inspection documents
ISO 14284:1996 Steel and iron - Sampling and preparation of samples for the determination of chemical composition
ISO 404:1992 Steel and steel products; general technical delivery requirements
ISO 4885:1996 Ferrous products - Heat treatments - Vocabulary
ISO 6506-1:1999 Metallic materials - Brinell hardness test - Part 1: Test method
ISO 6892:1998 Metallic materials - Tensile testing at ambient temperature
ISO 6929:1987 Steel products; Definitions and classification Bilingual edition
ISO/TR 9769:1991 Steel and iron; review of available methods of analysis
ISO/TS 4949:2003 Steel names based on letter symbols