WARNING — Some of the tests described in this International Standard are considered hazardous. It
is, therefore, essential that, in conducting these tests, all appropriate safety precautions be strictly
adhered to. Attention is drawn to the danger of burst, fine jets (which can penetrate the skin) and
energy release of expanding gases. To reduce the hazard of energy release, bleed air out of test
specimens prior to pressure testing. Tests shall be set up and performed by properly trained
personnel.
This International Standard specifies uniform methods for the testing and performance evaluation of metallic
tube connections, stud ends for ports and flange connections for use in hydraulic fluid power applications. This
International Standard does not apply to the testing of hydraulic quick-action couplings, which is covered by
ISO 7241-2.
Tests outlined in this International Standard are independent of each other and document the method to follow
for each test. See the appropriate component International Standard for which tests to conduct and for
performance criteria.
For qualification of the connector, the minimum number of samples specified in this International Standard is
tested, unless otherwise specified in the relevant connector standard or as agreed upon by the manufacturer
and the user.
BS EN ISO 19879:2010 history
2021BS EN ISO 19879:2021 Metallic tube connections for fluid power and general use. Test methods for hydraulic fluid power connections
2010BS EN ISO 19879:2010 Metallic tube connections for fluid power and general use. Test methods for hydraulic fluid power connections