ASTM D7654/D7654M-10
Standard Specification for Asphalt Used in Roofing Measured by Dynamic Shear Rheometer

Standard No.

ASTM D7654/D7654M-10

Release Date

2010

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D7654/D7654M-10(2018)

Latest

ASTM D7654/D7654M-10(2018)

Scope

1.1 This specification covers two types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The specification is intended for general classification purposes only and does not imply restrictions on the slope at which an asphalt must be used.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D7654/D7654M-10 Referenced Document

• ASTM D1079 Standard Terminology Relating to Roofing and Waterproofing
• ASTM D140 Standard Practice for Sampling Bituminous Materials
• ASTM D2042 Standard Test Method for Solubility of Asphalt Materials in Trichloroethylene
• ASTM D5 Standard Test Method for Penetration of Bituminous Materials
• ASTM D6510 Standard Guide for Selection of Asphalt Used in Built-Up Roofing Systems
• ASTM D7175 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
• ASTM D92 Standard Test Method for Flash and Fire Points by Cleveland Open Cup

ASTM D7654/D7654M-10 history

• 2018 ASTM D7654/D7654M-10(2018) Standard Specification for Asphalt Used in Roofing Measured by Dynamic Shear Rheometer
• 2010 ASTM D7654/D7654M-10 Standard Specification for Asphalt Used in Roofing Measured by Dynamic Shear Rheometer