ASTM D6536/D6536M-00(2010)e1
Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser

Standard No.

ASTM D6536/D6536M-00(2010)e1

Release Date

2000

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D6536/D6536M-18

Latest

ASTM D6536/D6536M-18

Scope

This test method is to be used to measure the length of a specified dip tube from the bottom of the sealing surface to the end of the dip tube in a mechanical pump dispenser.

This test method is to be used to measure the exposed length of a specified dip tube of a mechanical pump dispenser.

1.1 This test method covers the measurement technique for a dip tube of a mechanical pump dispenser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D6536/D6536M-00(2010)e1 history

• 2018 ASTM D6536/D6536M-18 Standard Practice for Measuring the Dip Tube Length of a Mechanical Pump Dispenser
• 2000 ASTM D6536/D6536M-00(2010)e1 Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser
• 2000 ASTM D6536-00(2005) Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser
• 2000 ASTM D6536-00 Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser