ISO 1268-10:2005 PDF

Scope: This part of ISO 1268 specifies the general principles to be followed while injection moulding test specimens of bulk moulding compound (BMC) and gives details of mould designs for preparing one type of specimen for use in establishing reproducible moulding conditions. Where appropriate, this part of ISO 1268 may be applied to sheet moulding compound (SMC) formulated for injection moulding. Its purpose is to promote uniformity in describing the main parameters of the moulding process and also to establish uniform practice in reporting moulding conditions. The particular conditions required for the reproducible preparation of test specimens which will give comparable results will vary for each material used. These conditions are given in the International Standard for the relevant material or are to be agreed upon between interested parties. NOTE Tests have shown that mould design in an important factor in the reproducible preparation of test specimens. This part of ISO 1268 is intended to be read in conjunction with ISO 1268-1.

ISO 1268-10:2005 Referenced Document

ISO 10350-2 Plastics — Acquisition and presentation of comparable single-point data — Part 2: Long-fibre-reinforced plastics*， 2020-07-22 Update
ISO 10724-1 Plastics - Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) - Part 1: General principles and moulding of multipurpose test specimens
ISO 10724-2 Plastics - Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) - Part 2: Small plates
ISO 11403-1 Plastics — Acquisition and presentation of comparable multipoint data — Part 1: Mechanical properties*， 2021-06-18 Update
ISO 11403-2 Plastics — Acquisition and presentation of comparable multipoint data — Part 2: Thermal and processing properties*， 2022-07-19 Update
ISO 11403-3 Plastics - Acquisition and presentation of comparable multipoint data - Part 3: Environmental influences on properties*， 2021-05-31 Update
ISO 1268-1 Fibre-reinforced plastics - Methods of producing test plates - Part 1: General conditions
ISO 2577 Plastics - Thermosetting moulding materials - Determination of shrinkage*， 2007-12-01 Update
ISO 3167 Plastics - Multipurpose test specimens*， 2014-08-01 Update
ISO 472 Plastics — Vocabulary — Amendment 1: Additional items*， 2018-10-31 Update

2005 ISO 1268-10:2005 Fibre-reinforced plastics - Methods of producing test plates - Part 10: Injection moulding of BMC and other long-fibre moulding compounds - General principles and moulding of multipurpose test specimens