EN 15599-1:2010 Thermal insulation products for building equipment and industrial installations - In-situ thermal insulation formed from expanded perlite (EP) products - Part 1: Specification for bonded and loose-fill products before installation
This European Standard specifies the requirements for expanded perlite products which are used for the thermal insulation of building equipment and industrial installations with an operating temperature in the range of approximately-270 ℃ to +650 ℃.This European Standard specifies the requirements for the four types of expanded perlite products Perlite Aggregate (EPA), Coated Perlite (EPC), Hydrophobic Perlite (EPH) and Premixed Perlite (EPM), containing less than 1 % by mass organic material as determined by Annex C.This European Standard is a specification for the insulation products before installation.This European Standard describes the product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling.This European Standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.This European Standard does not cover factory made insulation products of formed shapes and boards made with expanded perlite, and does not cover products intended to be used for the insulation of buildings. The products covered byThis standard are not intended to be used primarily for airborne sound insulation or sound absorption applications although they may improve the performance of the installation in these respects when installed for their primary insulation intended use.
EN 15599-1:2010 Referenced Document
EN 1097-3:1998 Tests for mechanical and physical properties of aggregates - Part 3: Determination of loose bulk density and voids
EN 12087:1997 Thermal Insulating Products for Building Applications - Determination of Long Term Water Absorption by Immersion Incorporating Amendment 1: 2006
EN 12667:2001 Thermal performance of building materials and products - Determination of thermal resistance by means of guarded hot plate and heat flow meter methods - Products of high and medium thermal resistance
EN 13055-1:2002 Lightweight aggregates - Part 1: Lightweight aggregates for concrete, mortar and grout (Incorporating corrigendum May 2004)
EN 13055-2:2004 Lightweight aggregates - Part 2: Lightweight aggregates for bituminous mixtures and surface treatments and for unbound and bound applications
EN 13172:2008 Thermal insulating products - Evaluation of conformity
EN 13820:2003 Thermal insulating materials for building applications - Determination of organic content
EN 14706:2005 Thermal insulation products for building equipment and industrial installations Determination of maximum service temperature
EN 932-1:1996 Tests for general properties of aggregates - Part 1: Methods for sampling
EN 932-2:1999 Tests for general properties of aggregates - Part 2: Methods for reducing laboratory samples
EN 933-1:1997 Tests for Geometrical Properties of Aggregates - Part 1: Determination of Particle Size Distribution - Sieving Method including amendment A1:2005
EN 993-14:1998 Methods of Test for Dense Shaped Refractory Products - Part 14: Determination of Thermal Conductivity by the Hot-Wire (Cross-Array) Method
EN 15599-1:2010 history
2010EN 15599-1:2010 Thermal insulation products for building equipment and industrial installations - In-situ thermal insulation formed from expanded perlite (EP) products - Part 1: Specification for bonded and loose-fill products before installation