ISO 8779:2010
Plastics piping systems - Polyethylene (PE) pipes for irrigation - Specifications

Standard No.

ISO 8779:2010

Release Date

2010

Published By

International Organization for Standardization (ISO)

Status

Be replaced

Replace By

ISO 8779:2010/Amd 1:2014

Latest

ISO 8779:2020

Scope

This International Standard specifies the pipes (mains, sub-mains and laterals) with nominal outside diameters from 12 mm up to and including 63 mm made from polyethylene (PE) intended to be used for the conveyance of water for irrigation. It also specifies the general properties of PE and the test parameters for the pipes designated as PE 32 and PE 40 by checking referenced points as given in 4.4, to be used under the following conditions: ⎯ nominal pressures of PN 2,5, PN 4, PN 6, PN 8 and PN 10, as applicable, ⎯ at temperatures up to and including 45 ºC, as specified in Annex A.

ISO 8779:2010 Referenced Document

• ISO 1133-1 Plastics — Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics — Part 1: Standard method*， 2022-06-23 Update
• ISO 11357-6 Plastics - Differential scanning calorimetry (DSC) - Part 6: Determination of oxidation induction time (isothermal OIT) and oxidation induction temperature (dynamic OIT)*， 2018-03-01 Update
• ISO 1167-1 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids - Determination of the resistance to internal pressure - Part 1: General method
• ISO 1167-2 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids - Determination of the resistance to internal pressure - Part 2: Preparation of pipe test pieces
• ISO 11922-1 Thermoplastics pipes for the conveyance of fluids - Dimensions and tolerances - Part 1: Metric series*， 2017-12-31 Update
• ISO 18553 Method for the assessment of the degree of pigment or carbon black dispersion in polyolefin pipes, fittings and compounds AMENDMENT 1
• ISO 2505 Thermoplastics pipes — Longitudinal reversion — Test method and parameters*， 2023-08-12 Update
• ISO 3126 Plastics piping systems - Plastics components - Determination of dimensions
• ISO 4065:1996 Thermoplastic pipes - Universal wall thickness table
• ISO 4427-2:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 2: Pipes
• ISO 6964 Polyolefin pipes and fittings — Determination of carbon black content by calcination and pyrolysis — Test method*， 2019-02-27 Update
• ISO 8796 Polyethylene PE 32 and PE 40 pipes for irrigation laterals - Susceptibility to environmental stress cracking induced by insert-type fittings - Test method and requirements

ISO 8779:2010 history

• 2020 ISO 8779:2020 Plastics piping systems — Polyethylene (PE) pipes for irrigation — Specifications
• 2014 ISO 8779:2010/Amd 1:2014 Plastics piping systems - Polyethylene (PE) pipes for irrigation - Specifications; Amendment 1
• 2010 ISO 8779:2010 Plastics piping systems - Polyethylene (PE) pipes for irrigation - Specifications
• 2001 ISO 8779:2001 Polyethylene (PE) pipes for irrigation laterals - Specifications
• 1992 ISO 8779:1992 Polyethylene (PE) pipes for irrigation laterals — Specifications