ASTM C1697-10
Standard Specification for Blended Supplementary Cementitious Materials

Standard No.

ASTM C1697-10

Release Date

2010

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM C1697-16

Latest

ASTM C1697-21

Scope

1.1 This specification covers blended supplementary cementitious materials that result from the blending or intergrinding of two or three ASTM compliant supplementary cementitious materials, for use in concrete or mortar where hydraulic or pozzolanic action, or both, is desired. The supplementary cementitious materials include slag cement conforming to Specification C989, natural pozzolans and coal fly ash conforming to Specification C618 and silica fume conforming to Specification C1240.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 18212;The incorporation of supplementary cementitious materials as separate additions or as a manufactured blend may significantly alter the properties of fresh and hardened concrete. The user should be aware of these changes and is referred to the ACI Manual of Concrete Practice for information and guidelines. Specific reference is made to:

ACI 232.1R	Use of Natural Pozzolans in Concrete
ACI 232.2R	Use of Fly Ash in Concrete
ACI 233R	Slag Cement in Concrete and Mortar
ACI 234R	Guide for the Use of Silica Fume in Concrete

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM C1697-10 Referenced Document

• ASTM C114 Standard Test Methods for Chemical Analysis of Hydraulic Cement
• ASTM C1240 Standard Specification for Silica Fume Used in Cementitious Mixtures
• ASTM C125 Standard Terminology Relating to Concrete and Concrete Aggregates
• ASTM C150 Standard Specification for Portland Cement
• ASTM C151 Standard Test Method for Autoclave Expansion of Hydraulic Cement
• ASTM C183 Standard Practice for Sampling and the Amount of Testing of Hydraulic Cement
• ASTM C311 Standard Test Methods for Sampling and Testing Fly Ash or Natural Pozzolans for Use in Portland-Cement Concrete*， 2024-04-19 Update
• ASTM C618 Standard Specification for Fly Ash And Raw Or Calcined Natural Pozzolan For Use As A Mineral Admixture In Portland Cement Concrete
• ASTM C989 Standard Specification for Ground Granulated Blast-Furnace Slag for Use in Concrete and Mortars

ASTM C1697-10 history

• 2021 ASTM C1697-21 Standard Specification for Blended Supplementary Cementitious Materials
• 2018 ASTM C1697-18 Standard Specification for Blended Supplementary Cementitious Materials
• 2016 ASTM C1697-16 Standard Specification for Blended Supplementary Cementitious Materials
• 2010 ASTM C1697-10 Standard Specification for Blended Supplementary Cementitious Materials