DIN EN 14636-1:2010 PDF

Scope: This European Standard applies to pipes and fittings made from polyester resin concrete (PRC), intended to be used within a drain or sewer system operating without pressure. It applies to products for use in buried installations to be installed by open-trench techniques or pipe jacking. The intended use of these products is for the conveyance of sewage, rainwater and surface water at temperatures up to 50 ℃, without pressure or occasionally at a head of pressure up to 0, 5 bar, and installed in areas subjected to vehicle and/or pedestrian traffic. It specifies definitions, requirements and characteristics of pipes, fittings, joints, materials, test methods and marking.

DIN EN 14636-1:2010 Referenced Document

EN 1119 Plastics piping systems - Joints for glass-reinforced thermosetting plastics (GRP) pipes and fittings - Test methods for leaktightness and resistance to damage of non-thrust resistant flexible joints with elastomeric sealing elements
EN 13121-1 GRP tanks and vessels for use above ground - Part 1: Raw materials - Specification conditions and acceptance criteria*， 2021-08-31 Update
EN 637 Plastics piping systems - Glass-reinforced plastics components - Determination of the amounts of constituents using the gravimetric method
EN 681-1 Elastomeric seals Material requirements for pipe joint seals used in water and drainage applications Part 1: Vulcanized rubber (Incorporates Amendments A1: 1998 and A2: 2002; Incorporating Corrigendum August 2002; Incorporates Amendment A3: 2005)
EN 705 Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Methods for regression analysis and their use
EN ISO 3126 Plastics piping systems - Plastics components - Determination of dimensions ISO 3126:2005
EN ISO 75-2 Plastics - Determination of temperature of deflection under load - Part 2: Plastics and ebonite*， 2013-04-01 Update
EN ISO 9001:2008 Quality management systems - Requirements*， 2024-04-19 Update

2010 DIN EN 14636-1:2010-04 Plastics piping systems for non-pressure drainage and sewerage - Polyester resin concrete (PRC) - Part 1: Pipes and fittings with flexible joints; German version EN 14636-1:2009
2010 DIN EN 14636-1:2010 Plastics piping systems for non-pressure drainage and sewerage - Polyester resin concrete (PRC) - Part 1: Pipes and fittings with flexible joints; German version EN 14636-1:2009
0000 DIN EN 14636-1:2003