DIN EN 848-2:2010
Safety of woodworking machines - One side moulding machines with rotating tool - Part 2: Single spindle hand fed/integrated fed routing machines; German version EN 848-2:2007+A1:2009
- Standard No.
- DIN EN 848-2:2010
- Release Date
- 2010
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN EN 848-2:2013
- DIN EN 848-2:2013-01
- Latest
- DIN EN 848-2:2013
- DIN EN 848-2:2013-01
- Scope
- This document specifies all significant hazards, hazardous situations and events which are relevant to stationary and displaceable single spindle hand fed/integrated fed routing machines with fixed head but allowing only movement along the axis of the tool during machining, designed to cut solid wood, chip board, fibreboard, plywood and also these materials if they are covered with plastic laminate, edgings or veneer when they are used as intended and under the conditions foreseen by the manufacturer. This document does not apply to: inverted pin routers and radial arm routers, NC boring machines and NC routing machines, hand-held routers, routing machines set up on a bench or a table similar to a bench.
DIN EN 848-2:2010 history
- 2013 DIN EN 848-2:2013 Safety of woodworking machines.One side moulding machines with rotating tool.Part 2: Single spindle hand fed/integrated fed routing machines; German version EN 848-2:2007+A2:2012
- 2010 DIN EN 848-2:2010 Safety of woodworking machines - One side moulding machines with rotating tool - Part 2: Single spindle hand fed/integrated fed routing machines; German version EN 848-2:2007+A1:2009
- 2007 DIN EN 848-2:2007 Safety of woodworking machines - One side moulding machines with rotating tool - Part 2: Single spindle hand fed/integrated fed routing machines; German version EN 848-2:2007
